Skip to main content

Royal Mold Specialist

How to fix water damage on a phone: pull it from the water, power it off, remove the case, SIM tray and any removable battery, wipe it with a lint-free cloth, and let it dry in a sealed container with silica gel packets for at least 48 hours. Skip rice, heat and charging. Acting fast matters, since the chance of reviving a wet electronic device is roughly 70 percent.

Moisture does its worst damage where you can't see it, and it keeps working after the water is gone. Get the water out fast, and don't trap what's left. This guide gives you the order of operations for a wet phone.

What to Do in the First Minute After a Phone Gets Wet

You have seconds, not minutes, to limit the damage. Every second of contact gives liquid more time to reach the circuit board. You're not alone in this: a 2024 SquareTrade study found 78 million people in the U.S. reported damaging a mobile device within a single year.

Work through these steps in this order:

  1. Get the phone out of the water. Pull it out immediately. The shorter the contact time, the less liquid works its way inside.
  2. Power it off. Hold the power button and shut it down right away. Water on a live circuit board can short it, and a short circuit is what turns a recoverable phone into a dead one. Don't wait for the screen to flicker or die first.
  3. Strip off everything that comes off. Remove the case, the SIM card tray, any SD card, and the battery if your model has a removable one. Cases hold water against the phone's body, and open trays give moisture a way out.
  4. Skip the buttons. Don't press keys, swipe the screen, or plug anything in "just to check." Each press can push liquid deeper or complete a circuit.

That is the whole first minute. Don't try to dry it yet. Getting it off and open to air comes first, and the drying method comes after.

Speed matters because the odds shift with time. Intel's guidance on drying wet devices puts the chance of getting a wet electronic device working again at roughly 70 percent. That figure dates from 2012, so treat it as a rough historical estimate rather than a promise. Still, the people who beat those odds are the ones who acted fast and left the phone off.

Should You Rinse a Phone Exposed to Salt Water or Pool Water?

You should rinse a phone only if it was exposed to salt water, pool water or a sugary drink. Clean fresh water needs no rinse, but salt, chlorine and sugar leave residue that keeps damaging the phone after the water itself is gone.

Here's the difference. Plain tap water mostly evaporates. Ocean water, pool water, soda, juice and coffee leave dissolved minerals, chemicals or sugar. Salt and chlorine are corrosive, and as the liquid dries, that residue sits on the contacts and circuit board. Corrosion builds slowly. A phone can power on after a dunk and still fail weeks later as those residues eat at the metal.

If your phone went into salt water, a pool, or something sweet, rinse it briefly with fresh tap water to flush the residue out. Keep it quick and gentle. A short pass under a low, cool tap is enough. Don't blast it, and don't soak it. [S4] Do this after the phone is powered off and stripped of its case and trays, never before.

South Floridians run into this more than most. Beach days, pool decks and boat trips mean salt and chlorine are the usual culprits here, so this step matters in our area. Asurion's internal data shows liquid damage claims on smartphones peak between June and August, right in the middle of our hot season.

If your phone only touched clean water, such as a sink, a puddle of rainwater or a splash, skip the rinse and go straight to wiping and drying. More water on a phone that doesn't need it only adds to the problem.

How to Fix a Water Damaged Phone With Silica Gel and Patience

Once the phone is off and stripped down, the repair is mostly waiting. The correct drying method is a gentle wipe, a light tap to clear trapped liquid, and a sealed container with silica gel packets for at least 48 hours. [S8]

Follow these steps in order:

  1. Wipe the exterior. Use a soft, lint-free cloth and dab the surface dry. Don't rub hard, because aggressive rubbing can push water into seams and crevices.
  2. Tap out trapped liquid. Hold the phone with the charging port facing down and tap it gently against your palm. Gravity does the work here. Don't shake it hard.
  3. Seal it with silica gel. Put the phone in an airtight container along with several silica gel packets. Silica gel is the small desiccant packet you find in shoeboxes and new electronics, and you can buy it in bulk. The container has to be sealed, since the gel pulls moisture out of the phone only when it isn't also fighting the surrounding room air.
  4. Wait at least 48 hours. Leave it alone. Don't open the container early to check, and don't power it on. Patience is the biggest factor in getting a wet device back to working order, so give the gel the full time.

Silica gel is cleaner and more effective than the kitchen alternatives. It absorbs moisture efficiently and leaves no starch or dust inside the device.

After the full 48 hours, take the phone out and power it on. If it starts normally, check the speaker, microphone, camera and charging port before you trust it again. If it won't start, don't plug it in to "force" it. Hold off and move to the professional options covered later in this guide.

Can Rice Fix a Water Damaged Phone?

No, rice cannot reliably fix a water damaged phone. It is the most repeated phone-rescue myth and a poor drying method, while silica gel does the same job with far less risk to your phone.

Rice absorbs moisture slowly and weakly, so it pulls little water out of a phone's tight internals. It also sheds fine dust and starch. Those particles can slip into the charging port, headphone jack and speaker grilles, where they sit and cause new problems. You end up with a phone that's still wet inside and now carries debris too.

The other cost is time. Every hour you spend waiting on a bowl of rice is an hour the liquid sits against the circuit board. If you act early with the right material, you protect the odds covered earlier.

Silica gel is built for this. It's a desiccant, meaning a material engineered to grab moisture from the air around it. It works efficiently inside a sealed container and leaves no starch or dust behind. If you don't have packets on hand, check old shoeboxes and the pouches that come with new electronics, or buy a bulk pack. A pack costs little next to the repair bill, and it keeps the drying plan in this guide on track.

What Not to Do: Heat, Compressed Air, Charging and Swollen Batteries

The wrong move can turn a recoverable phone into a dead one. When water gets into a phone, these are the mistakes that do the most harm.

Each of these items makes things worse, and you should skip all of them:

  • Hairdryers and ovens. Heat can warp internal parts, damage the battery and melt adhesive seals. It can also drive moisture deeper into the phone instead of out of it.
  • Compressed air or blowing into ports. Forced air pushes liquid further inside, past the point where it can drain or evaporate.
  • Charging the phone. Plugging in a wet phone sends current through a damp circuit board. That can short components that were otherwise fine.
  • Pressing buttons or testing the screen. Every press risks completing a circuit while liquid is still inside.
  • Sunny windowsills and hot cars. Florida sun in a parked car builds heat fast. Keep the sealed container in a cool, dry room.

Now the battery, which needs its own warning. Phones use lithium-ion batteries, and liquid exposure can damage them. Watch for these signs of a swollen or failing battery:

  • A bulging back or screen. The case lifts, gaps open along the seams, or the display pushes up from the frame.
  • A phone that rocks on a flat surface. A swollen battery can make the device wobble.
  • Unusual heat or a sharp chemical smell. Either one means the battery is in trouble.

If you see any of these, stop. Don't charge the phone, don't press on the bulge, and don't try to pierce or pry the battery out. A damaged lithium-ion battery can catch fire. Power the phone down if it's on, move it away from anything flammable, and take it to a professional repair shop or an authorized service center. Many shops and electronics recyclers handle damaged batteries safely.

How to Fix Water Damage on an iPhone or Samsung Phone

The steps are the same for both. Power off, strip it down, rinse only if the liquid was salty, chlorinated or sugary, wipe, tap, and dry it in a sealed container with silica gel for at least 48 hours. Whether you're working on an iPhone or a Samsung, the physics of moisture don't change by brand.

What changes is how much you trust the phone's water resistance. Both brands sell models with an IP rating, which stands for Ingress Protection and tells you how well a device resists dust and water. Standard IP68 typically guarantees protection for a maximum of 30 minutes at a depth of 1.5 meters, according to Samsung. That is a lab-tested limit under clean, still water. Salt water, pool chemicals, hot water, soap and age can all push a phone past it. Seals also wear down over time, so an older phone protects less than a new one.

Marketing can overpromise here. Samsung's Australian division was fined AU$14 million for misleading claims about the swimming-safe capabilities of its devices. The lesson for you: a water-resistant phone that survives a dunk may still have moisture inside, so follow the full drying routine anyway.

Cost matters in the repair-or-replace call. SquareTrade research puts the typical expense of fixing or replacing a smartphone at $302. Note that this figure comes from a vendor, and your actual quote depends on your model and the shop. If a repair estimate approaches the price of a new phone, replacement may make more sense.

When to Stop and Get Professional Repair or Data Recovery

Stop the DIY routine when the phone gives you a clear signal it won't recover on its own. Four signs say it's time to hand it over:

  • No power after 48 hours. If it stays dead after a full drying period, more waiting won't help.
  • Swelling. A bulging battery means you stop and get it to a professional, as covered above.
  • Screen artifacts. Lines, flickering, color bleed or dead patches point to liquid on the display or board.
  • Visible corrosion. Green or white crusting in the charging port or SIM slot means residue is already eating the metal.

A repair shop can open the phone, clean corroded parts, and replace a failed battery, screen or port. It can't promise a rescue. Data recovery is a separate, specialized job that sometimes works on a dead phone, but nobody can guarantee it, and encryption makes it harder. Your safest data plan is a backup you made before the dunk, since a typical smartphone repair or replacement runs about $302.

If the water came from a leak, flood or burst pipe, the phone is only part of the problem. Standing moisture in walls and floors can lead to mold, so a water damage restoration service in Dade County, FL can help dry out the building itself. For mold questions after a leak, you can also check with Royal Mold Specialist.

Prices and plan limits verified as of November 2026.

FAQs

Will a phone dry out by itself?

Sometimes, but leaving it to chance is risky. Water trapped inside can corrode the board even after the outside feels dry. Power it off, strip it down and seal it with silica gel for at least 48 hours.

Will water damage go away on its own?

No. Corrosion keeps working after the liquid evaporates, especially from salt water, chlorine or sugary drinks. A phone that seems fine now can fail weeks later, so treat any dunk seriously even if the screen lights up.

Can you charge a phone right after it got wet?

No. Plugging in a damp phone sends current through wet circuitry and can short components that were otherwise fine. Wait out the full 48-hour drying period before you connect any cable, and only if the phone shows no swelling.

Does water damage show up later even if the phone turns on?

Yes. Corrosion builds slowly, so a phone that boots normally can develop speaker, camera, charging or battery problems days or weeks later. Check every function after drying and back up your data right away.

Is a water resistant phone safe after one dunk?

Not automatically. IP ratings cover limited time and depth in clean water, and seals weaken with age. Salt water, pool chemicals and hot water can get past them. Dry the phone fully and watch it for problems afterward.

How long should I wait before turning a wet phone back on?

Wait at least 48 hours in a sealed container with silica gel packets. Don't open it early to check. If the phone won't start after that, don't force a charge. Take it to a repair professional.

Conclusion

You can save a wet phone if you act fast and keep it simple. Get it out of the water, power it down, strip off the case and trays, rinse only if the liquid was salty, chlorinated or sugary, then dry it with silica gel for at least 48 hours. Rice, heat and charging only make the odds worse.

Back up your phone today, before anything gets wet. Then put a few silica gel packets in a spot you can reach quickly. If a phone shows swelling, stays dead after two days, or shows corrosion, take it to a professional instead of pushing further.

About the Author

Orel Zarger
Royal Mold Specialist
Experienced mold remediation professional serving homeowners and businesses throughout South Florida.